| Cause 1: |
The power to the device is not turned on. |
| Action: |
Turn the device's power on. |
 |
|
|
|
| Cause 2: |
The network board is not properly connected. |
| Action: |
Turn the device's power off, confirm the following, and then turn the device's power back on.
|
Refer to the network board manual, and confirm that the network board is installed correctly. (This operation is not necessary when using a device that offers standard support for network functions.)
|
|
|
Refer to the network board manual and confirm that the device is connected to the network using the correct cable.
|
|
|
If you are using 10Base-2, make sure that the network terminators are properly connected.
|
|
|
|
|
|
| Cause 3: |
The device's frame type is not correctly set. |
| Action: |
Set a frame type that suits your system. You can make the setting with NetSpot Device Installer for TCP/IP. |
|
|
|
|
